Silicone Mould - Hulk Fist - S467 cow Shake well before use

Shake well before use

Crafted from high-quality stainless steel

Approx 4cm

This embosser design is 60mm

keep below 50 degrees/c (122 degrees/f)

Silicone Mould - Hulk Fist - S467 cow Shake well before useInstructions: For the best details, lightly dust the mould with cornflour or icing sugar. Press in small amount of sugar paste, gumpaste or fondant, roll gently over the silicone mould with the rolling pin and remove the excess paste with the sharp knife. Tip: For a easy release, put the mould in a freezer for about 30 seconds, or bit longer if needed. Once the gum paste has hardened up a bit, turn the mould over, and the item should pop out easily.